|
Stats : Body |
- Body
- ALL metal pieces on the car/frame were sandblasted and painted with Eastwood Chassis Black or powder coated
- Rust and Repair
- Purchased my own 120V MIG welder and learned how to weld
- Replaced or repaired
- Complete driver floorpan, seat frame support, and toeboard
- Passenger rear floorpan
- Lower cowl area above fusebox
- Subframe bolt plates
- Driver firewall near horn relay
- Passenger firewall near blower motor
- Created plate and welded in A/C evaporator box hole in firewall
- Paint and Body Shop
- Further replaced or repaired by body shop
- Passenger rear quarter panel below side marker light
- Passenger rear trunk lower side panel
- Front windshield lower channel
- Passenger lower rear window
- Paint
- DuPont paint and clearcoat
- Color Code: 29Y
- Color Name: Titanium Metallic Gray
- Final Modifications
- Added passenger door side-view mirror
- Blacked-out front plastic grills
|
|
Stats : Engine / Trans |
- Short Block
- Pontiac 400 block bored .030 over
- Square-decked
- Crank lightened and balanced
- Stock rods lightened and balanced
- ARP rods bolts
- Forged pistons lightened and balanced
- Windage tray
- Viton rear main seal
- Cam: 214 intake / 224 exhaust @ .050
- Heads
- 6X-4 Heads
- Intake valves 2.11, exhaust valves enlarged to 1.77
- Ported and polished
- Oil drain passages de-burred
- Milled .020 to help increase compression
- Bronze valve guides
- Comp Cam Magnum 1.52 roller-tip rockers
- RA-IV 11/32" pushrods
- Pushrod holes widened for larger RA-IV pushrods
- Transmission
- Rebuilt 200R-4 (4-speed automatic from '87 Buick Grand National)
- 2500 stall torque converter
- Shiftworks 4-speed shifter detent conversion kit
- New speedometer cable
- Accessories
- Rodney Red radiator
- Internally regulated alternator
- Rebuilt power steering pump
- Edelbrock Performer intake manifold
- Quadrajet carburetor
- Carter high-volume mechanical fuel pump
- Jeg's high-torque mini-starter
- Mallory Promaster coil
- Mallory Unilite vacuum advance distributor
- Taylor 8mm custom spark plug wires
- Misc
- Approximate compression ratio of 8.6:1, perfect for pump gas
|
|
Stats : Mechanical |
- Brakes
- SSBC Front Disc Brake Conversion Kit
- New Disc/Drum brass proporting valve from 2nd Gen Firebird
- Complete set of new brake lines, front to back
- Rear Axle
- Completely cleaned and painted
- Original 2.79 Open rear gears
- Original driveshaft with new Spicer U-Joints
- New 4-leaf rear springs
- KYB Gas-A-Just Shocks
- Fuel
- Complete set of new fuel lines
- New fuel tank sending unit
- Refubished fuel tank w/ anti-squeak straps
- Subframe
- P.S.T. Polygraphite Super Front End Kit
- P.S.T. Polygraphite Subframe Body Mounts
- 1 1/8" Front Sway Bar
- New steering center link
- New steering rag joint
- New front coil springs
- KYB Gas-A-Just Shocks
- Misc
|
|
Stats : Exhaust |
- Hedman 4-tube ceramic coated headers w/ ball collectors
- Flowmaster American Thunder Exhaust System
- 2.5" Dual Tube w/ H-pipe
- Flowmaster Deltaflow-40 Series mufflers
- All mandrel-bent tubing
- Custom fit
- Completely welded
- Painted with 1200 degree high-temp aluminum paint
|
|
Stats : Interior |
- Complete car interior covered with eDead (like Dynamat) to reduce road noise and outside heat
- Front Seats
- Replaced broken side springs
- Replaced all seat foam
- Recovered with all new vinyl
- New handles, bumpers, and escutcheons
- Rear seat was cleaned and painted with SEM Landau Black vinyl paint
- Door panels
- Original door and quarter panels were cleaned and painted with SEM Landau Black vinyl paint
- New door panel arm rests and pads
- New window cranks, door handles, and lock knobs
- Windows
- All windows were removed, cleaned, and polished with a Rhodite polishing compond from Eastwood
- New lower rollers were installed in both quarter windows
- Seat belts
- Original gold seat belts were removed, cleaned, and dyed black
- Original metal buckle hardware was used with new plastic covers and buttons
- Sunvisors
- Original gold sunvisors were cleaned and painted with SEM Landau Black vinyl paint
- New sunvisor support brackets were installed with new nylon bushings
- New interior parts
- Carpet and padding
- Kick panels
- Headliner
- All weatherstripping
- Complete molding set all around headliner
- A-Pillar Post Molding
- Rear deck shelf
|
|
Stats : Electrical |
- Radio
- Deck: Pioneer In-Dash CD Player w/ MP3 playback (DEH-P3700MP)
- Front Speakers: Pioneer 4x6 2-way (TS-G4640R)
- Rear Speakers: Pioneer 6x9 3-way (TS-A6971R) w/ custom mounting spacers
- Subwoofer: Infinity Basslink (10" w/ 200 watt amp)
- Complete car interior covered with eDead (like Dynamat) to reduce road noise and outside heat
- Custom RCA, speaker, and power wiring
- Electrical
- All original wiring inspected and re-covered in black wire loom wrap
- Custom electrical wiring
- Custom secondary fuse panel for accessories
- Custom ground block
- H4 headlights
- CD/MP3/FM deck
- Vintage Air main box
- Vintage Air control panel
- Tri-gauge pod (oil, temp, volt)
- Tachometer
- Starter kill switch
- Coil kill switch
- Headlights
- Upgraded to H4 Xenon modern headlights
- Custom wiring harness, direct to battery
- Custom H4 electrical plugs
- Modified headlight mounting plate
|
|
|